Quote:
Originally Posted by jD_Empath
for those of us who are of the "smaller mass" variety and climb hills fast...
I have noticed since I started racing this year that I very rarely get passed going uphill on hilly time trials (I do pass people). I do get passed downhill though, and on the flats. Lots of riders are heavier than me.
In road races, the same thing tends to be true. I can create a rather large gap on a long climb, but if there is a long flat stretch after the downhill, it is more likely that I will get chased down.
Of course I am doing my best to increase my watts output so that I can hold them off as long as possible, but I am wondering if anyone has any technique suggestions regarding descending and flats using a regular road bike (not a TT bike). Most of the descents around here are not full of sharp corners so I almost never have to use the brakes. Basically, I am just trying to get as aero as possible in the drops, and pedaling as fast as I can if necessary on the downhills to add some speed. Drafting is not possible if you are in the lead!
Anyone have any suggestions for holding off the pack? (other than the obvious "increase your watts") |
The following 'rant' is aimed more at the downhill part of things:
I'm assuming that your little legs are spinning around like "bees wings" on the downhills. If you're pedalling as fast as you can then you're not using a big enough gear. Other than that you're suffering from the "little people" syndrome - unaero position......
Case in point. The bike you see me riding in the avatar - I knocked 4 minutes off my previous best time in a very hilly 25 mile time trial, mainly because I changed the gearing - and this was including riding almost 3 miles on a flat back tire ( I did 1hr 3min). Most people laughed at the fact that I had 57x11 top gear - yet I didn't see too many people on their tri-bars at over 45mph on the descents. I was doing over 100rpm in places and I don't like to pedal fast as it is, let alone on the aero bars.
If you're riding a road bike then think of it this way - you're most efficient at a specific rpm - if you have a critical part of the course that requires a "spectacular effort" then you need to be near optimal efficiency. Just because you're going downhill doesnt mean that you NEED to pedal at 130rpm in 53x12 just because someone says you have too. YOU need to define what you need to do.
IF the only way you can keep 55mph on a descent is with 55x11, for example, and you have a good descent on the course that your race is on, then it doesn't take rocket science to figure out what you need - regardless of what 'the regular people' say.
You spend hundreds of hours training each year to go faster - spend at least 2 hours of testing to figure out what makes you faster downhill each year and you may get a victory or two that you've not had before.
Good luck!
However, on the flats you'll need to make a special effort to be more aerodynamic. On the flats it's more "power to drag" ratio. It's a hard task - but look at those who are 'small of stature' like Chris Boardman. You're smaller but you need to somehow get yourself in that tucked position that only larger riders seem to be able to get themselves into. Don't worry too much - you're in the same boat as Iban Mayo. :P